Digivoice Decoder Programming

1038-35/34 Programming
  • Briefly press the button on the 4-way decoder.The LED should come on (NOT flashing).
  • At the entrance panel (for systems with more than one entrance panel, any panel can be used) press 1 then press the BELL.
  • Enter the apartment number connected to output A of the decoder and press the BELL.
  • Now enter the apartment number connected to output B of the decoder and press the BELL.
  • Enter the apartment number connected to output C of the decoder and press the BELL.
  • Enter the apartment number connected to output D of the decoder and press the BELL.
  • The decoder is now programmed and the LED will have gone off.
  • Repeat the process for the rest of the decoders.
  • If all four outputs are not being used, after you have finished entering apartment numbers, go back to the decoder and press the button to switch the LED off.

Quick Start Guide

To get you started you can click here to read our quick start guide...

Quick Start...

Keypad Instructions

1156-10, 1105-2, 1105-3 and 1158-46...

Instructions...

Fault Finding

On this site we have a number of pages that should help you when you are fault finding...

Find Product...

Programming a Product

On this page we have a number of sections that should help you when you are programming a product...

Find Product...

Identify A Product

On this site we have a number of pages that should help you identify a product...

Find Product...

01376 556010
Option 2 for Technical
or email
technical@urmet.co.uk